STD11의 선삭 시 절삭력 예측 및 요인별 상관계수 도출
(주)코리아스칼라
- 최초 등록일
- 2016.04.01
- 최종 저작일
- 2013.08
- 7페이지/
어도비 PDF
- 가격 4,000원
![할인쿠폰받기](/images/v4/document/ico_det_coupon.gif)
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국기계기술학회
ㆍ수록지정보 : 한국기계기술학회지 / 15권 / 4호
ㆍ저자명 : 이이선, 배명일
목차
Abstract
1. 서론
2. 실험장치 및 방법
2.1 실험장치
2.2 실험방법
3. 실험 결과 및 고찰
3.1 주분력(Principal force)
3.2 배분력(Radial force)
3.3 이송분력(Feed force)
3.4 변수 간 상관계수 비교를 통한 주 효과 분석
3.5 회귀방정식의 검증
4. 결론
참고문헌
영어 초록
In this study, we were turning STD11 and was carried out to presume for mutual relation of turning condition to get optimum cutting force(principal, radial, feed force) and experimental equation by variance, correlation coefficient and multi regression analysis with whisker reinforced ceramic tool. To predict cutting force, analyze principal, radial, feed force with multi-regression analysis. Results are follows: From the analysis of variance, affected factor to cutting force feed rate, depth of cut, cutting speed in order and cutting speed was very small affect to cutting force. From multi-regression analysis, we extracted regression equation and the coefficient of determination(R2) was 0.84, 0.88, 0.7 at principal, radial and tangential force. It means regression equation is significant. From the experimental verification, it was confirmed that princial, radial and tangential force was predictable by regression equation. Through the analysis of the correlation coefficient between each component forces and surface roughness, the principal force was found to have the greatest impact
참고 자료
없음
"한국기계기술학회지"의 다른 논문
더보기 (5/10)