접착된 알루미늄 폼의 전단 피로 해석에 대한 연구
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국기계기술학회
ㆍ수록지정보 : 한국기계기술학회지 / 15권 / 6호
ㆍ저자명 : 조호선, 조재웅
ㆍ저자명 : 조호선, 조재웅
목차
Abstract1. 서론
2. 해석모델 및 구속 조건
2.1 해석모델
2.2 해석 조건 설정
3. 해석결과
3.1 t=25mm인 모델의 피로해석 결과
3.2 t=45mm인 모델의 피로해석 결과
3.3 t=65mm인 모델의 피로해석 결과
3.4 피로 Cycle에 따른 반력 및 변위 그래프의 비교
4. 결론
후기
References
영어 초록
Adhesive joint method has been used instead of welding, reveted joint, bolt and nut in various industry fields recently. Aluminum foam has hole or crack on adhesive interface which is different from common composite material. To investigate shear characteristic of adhesive interface between aluminum foams, double cantilever beams(DCB) with thicknesses of 25mm, 45mm and 65mm bonded with single-lab joints are designed. The relation between nodes at finite element model is important to investigate adhesive strength in this study. All meshes are generated and some nodes are located on adhesive zone along collinear axis. As reaction force obtained by static experiment is applied, fatigue analysis is carried with 10Hz. In advance, adhesive property is obtained by preliminary experiment for applying adhesive strength to input into simulation analysis. With these conditions, the analysis results show that 2.97MPa, 3.10MPa and 4.2MPa of maximum equivalent stresses are shown respectively in case model thicknesses are 25mm, 45mm and 65mm. By use of the simulation result at this study, it is possible to find adhesive behavior of aluminum foam and be applied to real adhesive joint structure without experiment by sparing experimental cost and time참고 자료
없음태그
"한국기계기술학회지"의 다른 논문
- 다구찌 실험기법을 적용한 가리비 어구 세정기 개발에 관한 연구11페이지
- 컨베어 시스템과 열판 프레싱에 의한 승화 전사 생산 공정의 개선6페이지
- 핀튜브 자동절단장치 개발7페이지
- 인서트 팁 방식 원형 톱의 가공 특성에 대한 연구6페이지
- 통계적 기법을 이용한 자동차 타이어 도로소음에 관한 연구6페이지
- 하이브리드 스캐폴드의 간헐적인 기계적 자극에 대한 영향6페이지
- 구동축에 의한 차량의 구조음장 해석에 관한 연구8페이지
- 용접 전극봉용 커터의 경화 열처리에 관한 해석적 연구6페이지
- 수직축 소형풍력발전기의 허브 구조 변경에 관한 연구6페이지
- 전압 관찰을 위한 CMOS 전압 조절기 설계6페이지