고온 노출 니켈기 초내열합금 터빈 블레이드의 Cr/Ti/Al 성분이 고온 산화에 미치는 영향
(주)코리아스칼라
- 최초 등록일
- 2023.04.10
- 최종 저작일
- 2023.02
- 10페이지/
어도비 PDF
- 가격 4,000원
![할인쿠폰받기](/images/v4/document/ico_det_coupon.gif)
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국재료학회
ㆍ수록지정보 : 한국재료학회지 / 33권 / 2호
ㆍ저자명 : 최병학, 한성희, 김대현, 안종기, 이재현, 최광수
목차
Abstract
1. 서 론
2. 실험 방법
3. 실험 결과
3.1. 산화층 두께 및 전파 양상
3.2. 고온 노출 전 블레이드 열처리 상태의 산화층 분석
3.3. 고온 노출 상태의 블레이드 산화층 분석
4. 고 찰
4.1. 고온 산화 기구
5. 결 론
Acknowledgement
References
영어 초록
High-temperature oxidation of a Ni-based superalloy was analyzed with samples taken from gas turbine blades, where the samples were heat-treated and thermally exposed. The effect of Cr/Ti/Al elements in the alloy on high temperature oxidation was investigated using an optical microscope, SEM/EDS, and TEM. A high-Cr/high-Ti oxide layer was formed on the blade surface under the heat-treated state considered to be the initial stage of high-temperature oxidation. In addition, a PFZ (γ’ precipitate free zone) accompanied by Cr carbide of Cr23C6 and high Cr-Co phase as a kind of TCP precipitation was formed under the surface layer. Pits of several μm depth containing high-Al content oxide was observed at the boundary between the oxide layer and PFZ. However, high temperature oxidation formed on the thermally exposed blade surface consisted of the following steps: ① Ti-oxide formation in the center of the oxide layer, ② Cr-oxide formation surrounding the inner oxide layer, and ③ Al-oxide formation in the pits directly under the Cr oxide layer. It is estimated that the Cr content of Ni-based superalloys improves the oxidation resistance of the alloy by forming dense oxide layer, but produced the σ or μ phase of TCP precipitation with the high-Cr component resulting in material brittleness.
참고 자료
없음