Effects of pressurized PFO‑based pitch coking conditions on coke yield and graphite conductivity
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국탄소학회
ㆍ수록지정보 : Carbon letters / 31권 / 5호
ㆍ저자명 : Jong Hoon Cho, Byong Chol Bai
ㆍ저자명 : Jong Hoon Cho, Byong Chol Bai
목차
Abstract1 Introduction
2 Experimental
2.1 Preparation of PFO-based pitch
2.2 Pressurized coking process
2.3 Characterization
3 Results and discussion
3.1 Polymerization characteristics of petroleum residue PFO
3.2 Characteristics of pitch depending on softening point
3.3 Yield and physical characteristics of coke produced by pressurized coking
3.4 Electrical characteristics of graphite powder
4 Conclusion
Acknowledgements
References
영어 초록
In the present study, pyrolyzed fuel oil (PFO)-based pitch without impurities was used to prepare coke under pressure, and the preparation yield and the powder resistance depending on the graphitization were investigated. The preparation yield of green coke by pressurized coking at 500 °C was about 26–27% higher than that at normal pressure. However, the coke yield after the thermal treatment of green coke at 900 °C was lower by 10.6–14.8% at the pressurization conditions than under normal pressure. This may be because the substances that are not vaporized under the pressurized conditions remain in the reactants and then are discharged later. The coke yield after the thermal treatment at 900 °C was higher by 14.9–28.3% under the pressurized conditions than under the normal pressure, indicating that the low-boiling point materials of the pitch participated more in coke polymerization under the pressurized conditions. The density of the coke prepared under the pressurized conditions was lower than that of the coke prepared under normal pressure, because the low-boiling point materials of the pitch participated in the reaction. However, after graphitization, the density values became similar (2.27–2.26 g/cm3). The volume resistivity of the graphitized samples was in a range of 0.499 × 10–2–0.384 × 10–2 Ω cm, indicating that the coke samples have similar electrical properties. The results of the present study show that, in comparison with the conventional normal-pressure process, the pressurized coking process can improve the yield through the participation of low-boiling point materials in the polymerization reaction, while maintaining the properties of the prepared coke and graphite, such as the conductivity and density.참고 자료
없음"Carbon letters"의 다른 논문
Hydrogenation effects on the thermal and magnetic prope..8페이지
Synthesis and characterization of microporous activated..10페이지
Comparison of ultrasonic‑treated rice husk carbon with ..7페이지
First‑principles calculation of volatile organic compou..10페이지
Coulomb mechanism of Raman radiation in graphene9페이지
Capacitive behavior of functionalized activated carbon‑..9페이지
Probe on hard carbon electrode derived from orange peel..7페이지
The use of semi‑coke for phenol removal from aqueous so..10페이지
Size dependent conduction characteristics of catalyst‑m..7페이지
Characterization of prepared eco‑friendly biochar from ..14페이지