기계실험1 보고서(총 6개, MMAE319 Lab Reports(6 Total), IIT,
- 최초 등록일
- 2016.06.01
- 최종 저작일
- 2015.05
- 3페이지/
압축파일
- 가격 18,000원
![할인쿠폰받기](/images/v4/document/ico_det_coupon.gif)
목차
1. Lab 1. Ohm’s Law with breadboard
2. Lab 4. Resistors, Voltage Dividers, RC Circuits, Multi-channel acquisition
3. Lab 6. Bending and Load Cell
4. Lab 9. Thermocouples and control via Labview
5. Lab 11. Convective Heat Transfer from a cylinder in a Cross Flow
6. Lab 13, Build a temperature controller completely in hardware
본문내용
Introduction
Objective:
The purpose of this experiment is to familiarize the equipments and construct the simple circuits on breadboards. Also, this experiment is to test the validity of Ohm’s Law.
Theory:
The theory of this lab is Ohm’s law, which is stated below (equation (1))
V=IR (1)
Where V = voltage (V), I = current through conductor (A), and R = resistance of conductor (Ω).
From the equation (1), the experimenters can approach the power to be dissipated. The following equation (2) shows the power to be dissipated.
P= v^2/R (2)
Where P = Power (W), V = voltage (V), R = resistance (Ω).
Figure 1. Schematic of Circuit
In the Figure 1, E = Power supply, A = Ammeter, V = Voltmeter, and R = Resistor.
Experimental Setup
Instruments:
Breadboard, Multi-meter, Oscilloscope, Power supply, and 5 Resistors.
Current is measured in series and voltage is measured in parallel for preventing a short.
참고 자료
없음
압축파일 내 파일목록
lab 9 319 Hyunjun Park.docx
lab 11 319 Hyunjun Park.docx
lab 13 319 Hyunjun Park.pdf
Lab Report1-Hyunjun Park.docx
lab 4 319 Hyunjun Park.docx
lab 6 319 Hyunjun Park.docx