인하대학교 수공시스템설계 homework #2
- 최초 등록일
- 2020.02.19
- 최종 저작일
- 2018.10
- 6페이지/ 한컴오피스
- 가격 1,000원
소개글
인하대학교 수공시스템설계 A+ 과제 #2
목차
1. Answer the following questions
2. The average rainfall and observed flow for some watersheds are shown in the table below. When the watershed area is , calculate the unit hydrographs.
3. Explain Antecedent Moisture Condition(AMC).
4. 어떤 호우에 대해 15시간 동안 3시간마다 관측한 강우강도가 1.2, 1.5, 0.9 2.2, 0.2cm/hr와 같았다. 지표면 유출이 25mm이고, 지면보유량은 총강우량의 5%이다. -지표법과 -지표법으로 침투능을 구하여라.
5. A jet of water discharges into an open tank, and water leaves the tank through an orifice in the bottom at a rate of 0.003 . if the cross-sectional area of the jet is 0.0025 where the velocity of water is 7 m/s, at what rate is water accumulating in (or evacuating from) the tank?(unit : kg/s)?
6. Determine the momentum coefficient , defined by Equation , for the stream-flow data given table below.
본문내용
1. Answer the following questions
(1) Unit hydrograph.
(a) Could you write why we want to get a unit hydrograph in a watershed?
단위도는 특정 지속기간동안 균일한 강도를 가지고 유역전체에 걸쳐 균등하게 내리는 단위 유효우량에 의해 발생하는 직접유출수문곡선으로 정의된다.
단위도는 다음과 같은 여러 가지 수문학적 문제 해결 또는 연구를 위해 이용되어진다.
1. 수공구조물설계를 위한 필요한 설계호우에 상응하는 홍수수문곡선
2. 유역유출 모의 모형
3. 홍수예경보 연구
4. 강우자료르르 토대로 한 홍수량 자료의 연장
(b) How can you get a unit hydrograph in the gaged watershed?
⦁계측 유역(gaged watersheds) : 유량 및 강우자료를 이용하여 단위도를 구한다.
- 자료 선별
① 단순호우
② 균일하게 분포된 강우강도를 갖는 호우사상
③ 강우의 공간적 분포가 균일한 호우사상
④ 유효유량의 범위 13mm~44mm
참고 자료
없음