• 통큰쿠폰이벤트-통합
  • 통합검색(50)
  • 리포트(48)
  • 논문(2)

"Maximum flow velocities" 검색결과 1-20 / 50건

  • 열유체실습 예비레포트 3
    velocity through the flow nozzle at the inlet is determined. where, v is the flow velocity, P is the ... velocity through the flow nozzle at the inlet is determinMAT2 ... The flow rate can be regulated using the adjusting flap (9).Check pressure display for velocity measurement.Displays
    리포트 | 11페이지 | 1,500원 | 등록일 2022.08.21
  • 항공기영어 날개골의 특징
    approach, when the angle of the attack is little, the leading edge of the wing can maintain the laminar flow ... Because of the thrust, an aircraft can have velocity which able to make forces of lift and drag. ... The relationship between velocity, lift and drag can be clearly found from the equations of lift and
    리포트 | 7페이지 | 1,000원 | 등록일 2020.11.23
  • 공정제어 hw2 applet4 Understand the Actuator, Control Valve
    가 sonic velocity에 다다르는 압력에 도달하면 flashing 이 일어나 flow에서 물이 vapor로 증발하게 되어 매우 시끄러워진다. ... outflow가 둔탁하게 반응 하는 모습을보였다.5.Air to open 일 때와 Air to close 일 때 command signal이 20ma로 같을 때 air to open은 gpm이maximum인 ... 하는데 그 때의 flow를 Choked flow라고 한다.
    리포트 | 8페이지 | 2,000원 | 등록일 2021.04.30 | 수정일 2021.05.04
  • Airfoil의 종류와 항공기에 작용하는 하중에 대하여 설명하시오.
    The maximum lift and the minimum drag of the aircraft can make an economical flight, so the shape of ... However, since drag is proportional to the amount of air flowing per hour, the amount of air flowing ... This is an airfoil with a position of maximum thickness near the center so that the drag coefficient
    리포트 | 7페이지 | 1,000원 | 등록일 2020.05.22 | 수정일 2020.05.25
  • 항공기술영어
    machine will depend upon the sustaining effect between a plane surface and one properly curved to get a maximum ... The lift force can be related directly to the average top/bottom velocity difference without computing ... flowfield about the airfoil has a higher average velocity on the upper surface than on the lower surface
    리포트 | 6페이지 | 1,000원 | 등록일 2021.03.03
  • 항공기 날개골의 종류 및 항공기에 작용하는 힘의 종류를 그림과 함께 특징에 대하여 영문으로 간단히 소개하시오
    The laminar-flow airfoils (NACA's six series) were shaped with their maximum thickness far back from ... Also, how well the wings a plane's velocity is in accordance with the change and design an airplane wings ... to a full wing.By the end of the 1930s, NACA aerodynamicists had turned their attention to laminar-flow
    리포트 | 9페이지 | 1,000원 | 등록일 2019.11.17
  • 수처리시설(수환경설계) 설계 계산파일(WWTP 설계)
    기준axial velocity0.3m/sec25920m/daysurface loading rate1800㎥/㎡/dayHRT(Hydraulic Retention Time)50sec30 ... length18meffective width0.3901meffective height1.25mvolume check8.7766㎥4. equalization basinthree times of hourly maximum ... ratewater consumption360L/person/daysewage consumption90%flow rate at the year of 203515850514L/day(
    리포트 | 2페이지 | 1,000원 | 등록일 2020.12.22 | 수정일 2020.12.28
  • 초음파 SPI 원리 초음파 물리2
    flow velocity4. ... Display* Analog signal- does not have discrete steps –values may vary continuously between minimum and maximum ... Damage to the lens or transducer crystals- result: degradation of image quality: underestimation of maximum
    리포트 | 7페이지 | 2,500원 | 등록일 2023.06.13
  • (A+) 인장, 압출, 압축 공정 시뮬레이션 보고서
    Reason Interface 의 중앙 부분에서 Friction 에 의해 Metal Flow 가 불균일 해지면서 Dead Zone 이 발생했기 때문이다 . ... 1 58 67 34.81 2 146 81 57.76 3 159 92 59.02 4 217 93 59.02 5 530 94 59.04 6 219 94 59.03 7 159 앙에서 Maximum ... 일정하게 유지되는 것을 알 수 있다 .Tension Reason Necking 발생 시 단면적이 급감하기 때문에 가장 큰 Stress 가 걸리며 가장 많은 변형이 일어나게 되므로 Maximum
    리포트 | 46페이지 | 2,500원 | 등록일 2020.02.04
  • IB diploma Physics HL IA
    height or when it already flowed out of the spout. ... The velocity can be either larger or smaller for each experiment. ... water is at the spout because there is a change in pressure when the water is not yet raised to the maximum
    리포트 | 12페이지 | 6,000원 | 등록일 2020.05.11
  • 풍동
    Lift coefficike region where the circulating flow is moving behind is made by separation of flow and ... D is a Drag force, U is a velocity of Air, is a density of air, lastly, A is Area, which is width * length ... those are almost symmetricTask#6As I wrote, Stall is a moment (or Phenomenon) when Air-foil could get maximum
    리포트 | 11페이지 | 1,500원 | 등록일 2022.12.17
  • 수처리시설(수환경설계) 설계 레포트(WWTP 설계)
    Equalization basin특별한 기준이 없으므로 정사각형으로 설계하였다.Three times of hourly maximum flow1579.7902㎥Depth(H)3mVolume1579.7902 ... {Q} over {V TIMES T TIMES v}#H=T TIMES v하수도 시설기준(2011)에 의해 수리학적 체류시간(HRT)은 30~60 sec를 만족해야 한다.Axial velocity ... Estimating sewage flow rateWater consumption360L/person/daySewage conversion rate90%Flow rate at the
    리포트 | 6페이지 | 1,500원 | 등록일 2020.12.22 | 수정일 2020.12.28
  • 경북대 응용유체역학 첫번째 과제 만점
    (a) Predict the y-component of velocity, v(x, y), in the duct. ... 22 we developed expressions for u, v, and r for flow through the compressible, two-dimensiona,문제에서 주어진 ... V=900*1000/3600;h=11500; rho_air=1.2; g= 9.81; rho_al=0.333;W=m*g;%%(a)C_max=3.48; C_min=1.52; %The maximum
    리포트 | 15페이지 | 1,500원 | 등록일 2019.12.30 | 수정일 2023.06.20
  • 항공기의 날개골의 종류 및 항공기에 작용하는 힘의 종류를 그림과 함께 특징에 대하여 영문으로 간단히 소개하시오
    Since the distance over the upper surface is longer, the flow of air must increase its velocity. ... thickness is the maximum thickness.6. ... The increase in velocity produces a corresponding decrease in pressure over the upper surface.
    리포트 | 6페이지 | 1,000원 | 등록일 2018.06.11
  • 열교환기설계
    heat flux q des : Design heat flux V i : Circulation velocity y o : 출구 증기분율 y a : 평균증기 분율 W t : Tube ... phases : 2 상 대류 열전달에서 혼합물 보정인자 : 증기의 전단효과의 보정인자 : 액체 대류 열전달 계수h i 계산과정 계산하기 위해서는 아래의 값들의 계산이 필요 q max : Maximum ... 이상일 때 mist flow 가 된다 .
    리포트 | 29페이지 | 1,500원 | 등록일 2017.04.16 | 수정일 2017.07.22
  • 항공기 날개골의 종류 및 항공기에 작용하는 힘의 종류를 그림과 각각의 특징에 대하여 영문으로 간단히 소개하시오.
    The maximum velocity produced by this wing at this angle of attack is approximately twice the free-stream ... In another region, we have a short fat parcel flowing by at a low velocity.The most remarkable thing ... In one region, we have a long, skinny parcel of air flowing past a particular point at a high velocity
    리포트 | 5페이지 | 1,500원 | 등록일 2016.11.14
  • 항공기 날개골의 종류 및 항공기에 작용하는 힘의 종류를 그림과 각각의 특징에 대하여 영문으로 간단히 소개하시오. 영문
    This elongates the wing and moves the point of maximum thickness back from the leading edge.Supersonic ... Lift acts through the center of pressure of the object and is directed perpendicular to the flow direction ... building, or the deck of a bridge, will generate an aerodynamic force (called lift) perpendicular to the flow
    리포트 | 6페이지 | 1,000원 | 등록일 2016.12.30
  • 성균관대 열유체공학설계실습 대류열전달 실험 결과레포트
    We calculate the Reynolds number from the flow velocity. ... for the heater temperature (20).⑤ Switch on the main switch (25).⑥ When the fan is switched on, the maximum ... Connect measuring connection for velocity to inclined tube manometer (measuring range 0 ~ 5000Pa).
    리포트 | 15페이지 | 3,000원 | 등록일 2017.12.25
  • 2018인하대(A+)수공시스템설계과제1,2
    Determine the maximum rainfall for the duration of 15-min, 30-min, 45-min, 60-min, 90-min, 120-min, 180 ... bottom at a rate of 0.003m ^{3} /s. if the cross-sectional area of the jet is 0.0025m ^{2} where the velocity ... The average rainfall and observed flow for some watersheds are shown in the table below.
    리포트 | 9페이지 | 2,000원 | 등록일 2019.01.15
  • [열유체공학설계실습] 풍동 실험 보고서-실습4
    } cos theta )ds _{l}}}=`rd theta ( sum _{i} ^{n} {vec{p _{u,i}}} cos theta _{u,i} + .5m` TIMES `3m* Maximum ... We find the velocity drop angle 32.5° that means the stall occurs. ... out the experiment in fully opened state.② Calibrate flow rate at inlet.③ Fix the angle of attack.④
    리포트 | 11페이지 | 2,000원 | 등록일 2016.10.02
  • 아이템매니아 이벤트
  • 유니스터디 이벤트
AI 챗봇
2024년 09월 15일 일요일
AI 챗봇
안녕하세요. 해피캠퍼스 AI 챗봇입니다. 무엇이 궁금하신가요?
1:07 오후
문서 초안을 생성해주는 EasyAI
안녕하세요. 해피캠퍼스의 방대한 자료 중에서 선별하여 당신만의 초안을 만들어주는 EasyAI 입니다.
저는 아래와 같이 작업을 도와드립니다.
- 주제만 입력하면 목차부터 본문내용까지 자동 생성해 드립니다.
- 장문의 콘텐츠를 쉽고 빠르게 작성해 드립니다.
9월 1일에 베타기간 중 사용 가능한 무료 코인 10개를 지급해 드립니다. 지금 바로 체험해 보세요.
이런 주제들을 입력해 보세요.
- 유아에게 적합한 문학작품의 기준과 특성
- 한국인의 가치관 중에서 정신적 가치관을 이루는 것들을 문화적 문법으로 정리하고, 현대한국사회에서 일어나는 사건과 사고를 비교하여 자신의 의견으로 기술하세요
- 작별인사 독후감
방송통신대학 관련 적절한 예)
- 국내의 사물인터넷 상용화 사례를 찾아보고, 앞으로 기업에 사물인터넷이 어떤 영향을 미칠지 기술하시오
5글자 이하 주제 부적절한 예)
- 정형외과, 아동학대